KitchenAid error code · F1E2
KitchenAid F1E2 Control Board Memory or Logic Fault
KitchenAid range F1E2 is a control board memory or logic fault. The ERC fails its internal check and usually requires replacement.
KitchenAid oven code F1E2 is a control board fault in which the electronic range control (ERC) detects a memory or logic error during its self-check. The main control board generally needs to be replaced.
What F1E2 means
F1E2 sits alongside F1E1 in the control-self-check family on the Whirlpool platform. It flags a failure in the board's stored program or its internal logic verification. Because the affected component is the oven's control processor, the unit cannot run cooking cycles reliably.
Severity:Service needed · Appliance:Range
Why F1E2 happens
Memory and logic faults usually stem from a corrupted program after a power surge or brownout, age-related failure of the onboard memory, or heat-stressed solder connections inside the control. They originate on the board itself rather than in the oven's sensors or elements.
Common causes
- Corrupted control board memory after a surge or brownout
- Failed memory chip or processor on the ERC
- Heat-stressed internal solder joints
- Age-related board degradation
- Onboard component short flagging the logic check
What you'll typically see
- F1E2 displayed, frequently at power-up
- Control will not retain settings or start a cycle
- Display freezes, blanks, or resets on its own
- Beeping with no response to inputs
- Code reappears after a reset attempt
Parts involved in F1E2
- Control board (ERC) — Primary fix; a memory or logic self-check failure is corrected by replacing the board
- Wiring harness connectors — Inspected to rule out a loose connection before replacing the board
What you can check yourself
- Power-cycle the oven at the breaker for two to five minutes
- Check whether a recent storm or power flicker preceded the code
- Confirm the fault is repeating, not a single event
- Keep the control housing closed and leave internal work to a technician
When to book a pro
Distinguishing a corrupted-but-repeating board fault from a momentary glitch, and confirming clean supply voltage, requires meter testing near line-voltage terminals. A technician confirms the board and replaces it safely.
Have this code?
Send us the code and your model — flat $89 diagnostic, 365-day warranty.
Book a technicianFrequently asked
F1E2 FAQ
What does F1E2 mean on a KitchenAid range?
It is a control board memory or logic fault. The ERC fails its internal check and the board usually needs to be replaced.
What is the difference between F1E1 and F1E2?
Both are control-board self-check failures. F1E1 is a general internal fault, F1E2 points more specifically to a memory or logic verification error. The fix is the same: replace the control board.
Can a power surge cause F1E2?
Yes. A surge or brownout can corrupt the board's stored program and trigger F1E2, which is why it often appears after a storm or power flicker.
Will a reset clear F1E2?
Occasionally a power-cycle clears a one-time event, but a genuine memory fault returns and the control board must be replaced.
Is the oven safe to use?
No, treat it as out of service until repaired, since the control cannot be trusted to run cycles correctly.
What does the repair involve and cost?
A technician confirms the board, replaces it, and verifies operation. The diagnostic visit is a flat $89 and the repair carries a 365-day warranty. Call (650) 668-1554.
Subzero Repair · Open 24/7 · 365-day warranty
Need KitchenAid repair in the Bay Area?
Call for urgent cooling or cooking failures, or book online for a service window across the Bay Area.